Shop for the Murrelektronik 56001 I/O system -

Sensor supply US: 24 V DC (EN 61131-2), max. 700 mA per module
Type: PNP (EN 61131-2)
Input filter: 1 ms
Galvanic isolation: 500 V DC between I/O and system electronics
Fieldbus: SUB-D9 (female)
Sensor-system/actuator supply: 4 x Spring clamp terminals, max. 2.5 mm^2 (max. 12 A)
I/O ports: 8 x Spring clamp plug-in terminals, max. 2.5 mm^2
Operating voltage: 24 V DC (EN 61131-2)
Sensor-system/actuator supply: via terminal UB
Current consumption: max. 150 mA
Operating modes: Sync- and freeze mode are supported
Transfer rate: to 12 Mbit/s
Addressing: Rotary switch 1 - 99
I/O capacity: with modular expandability by up to 15 Cube-modules
Protection: IP20
Mounting method: DIN-rail mountable (EN 60715)
Temperature range: 0 - 55 degrees Celcius (storage temperature -20 - 85 degrees Celcius)
Dimensions H x W x D: 117x56x47 mm
Terminal row X2 (4 channels): Input
Terminal row X3 (4 channels): Input
Communication status: via LED and BUS
Diagnostic via LED: per module
Diagnostic via BUS: per module and channel
Monitoring - under voltage: yes
Monitoring - no voltage: no
Short circuit and overload: yes

Murr Elektronik Cube20 series is an IP20 rated in-cabinet I/O system designed for ease of installation with a high I/O density in a single space. It can connect up to 15 I/O modules, which gives you up to 488 I/O connections within 90 cm. Cube20 was designed to minimize assembly time, so one part number for one I/O module is all that is necessary when ordering. The I/O modules are connected to each other with a built in ribbon cable for backplane communication and power. Easy to plan, easy to install, easy to adapt.

Advantages:
IP20 rating
Up to 488 I/O connections in 60 cm
Pluggable terminals with spring clamp wire terminations
Single part numbers - no assembly required
Backlit LED for diagnostics
Integrated Ethernet switch
Up to 15 I/O modules after a bus node
Ethernet/IP built in web browser
Din rail mounting