Shop for the Murrelektronik 56200 I/O system -

Conversion time (analog): max. 2 ms (per channel)
Resolution (analog): 15 Bit sign
Accuracy: max. 0.3%
Connection: Differential voltage/current input
Module Supply: via system connection
Current consumption: max. 25 mA from system, max. 60 mA externally (UI)
Fieldbus: Ribbon cable connection
Sensor-system/actuator supply: 4 x Spring clamp terminals, max. 2.5 mm^2 (max. 12 A)
I/O ports: 24 x Spring clamp plug-in terminals, max. 2.5 mm^2
Operating voltage: 24 V DC (EN 61131-2)
Protection: IP20
Mounting method: DIN-rail mountable (EN 60715)
Temperature range: 0 - 55 degrees Celcius (storage temperature -40 - 85 degrees Celcius)
Dimensions H x W x D: 117x56x47 mm
Input resistor: min. 1 MOhm, (EN 61131-2)
Input range: /-10 V DC, 0 - 10 V DC
Load: max. 300 Ohm (20 mA), (EN 61131-2)
Input range: 0 - 20 mA, 4 - 20 mA
Communication status: via LED
Diagnostic via LED: per module
Diagnostic via BUS: per module and channel
Monitoring - under voltage: yes
Monitoring - no voltage: no
Short circuit and overload: yes
Wire break upper/lower limit overload: per channel via LED and BUS

Murr Elektronik Cube20 series is an IP20 rated in-cabinet I/O system designed for ease of installation with a high I/O density in a single space. It can connect up to 15 I/O modules, which gives you up to 488 I/O connections within 90 cm. Cube20 was designed to minimize assembly time, so one part number for one I/O module is all that is necessary when ordering. The I/O modules are connected to each other with a built in ribbon cable for backplane communication and power. Easy to plan, easy to install, easy to adapt.

Advantages:
IP20 rating
Up to 488 I/O connections in 60 cm
Pluggable terminals with spring clamp wire terminations
Single part numbers - no assembly required
Backlit LED for diagnostics
Integrated Ethernet switch
Up to 15 I/O modules after a bus node
Ethernet/IP built in web browser
Din rail mounting