Shop for the Murrelektronik 56230 I/O system -

Conversion time (analog): max. 600 ms (per channel)
Type: Pt100, 200, 500; Ni100, 120, 200, 500, 1000, R 0 - 3000 Ohm
Resolution (analog): 15 Bit sign
Accuracy: 0.7 - 1.4%
Connection: 2-wire input: Rx, -Rx / 3-wire input: Rx, RLx, -Rx
Module Supply: via system connection
Current consumption: max. 25 mA from system, max. 70 mA externally (UI)
Fieldbus: Ribbon cable connection
Sensor-system/actuator supply: 4 x Spring clamp terminals, max. 2.5 mm^2 (max. 12 A)
I/O ports: 16 x Spring clamp plug-in terminals, max. 2.5 mm^2
Operating voltage: 24 V DC (EN 61131-2)
Protection: IP20
Mounting method: DIN-rail mountable (EN 60715)
Temperature range: 0 - 55 degrees Celcius (storage temperature -20 - 85 degrees Celcius)
Dimensions H x W x D: 117x56x47 mm
Communication status: via LED
Diagnostic via LED: per module
Diagnostic via BUS: per module and channel
Monitoring - under voltage: yes
Monitoring - no voltage: no
Short circuit and overload: yes
Wire break upper/lower limit overload: per channel via LED and BUS

Murr Elektronik Cube20 series is an IP20 rated in-cabinet I/O system designed for ease of installation with a high I/O density in a single space. It can connect up to 15 I/O modules, which gives you up to 488 I/O connections within 90 cm. Cube20 was designed to minimize assembly time, so one part number for one I/O module is all that is necessary when ordering. The I/O modules are connected to each other with a built in ribbon cable for backplane communication and power. Easy to plan, easy to install, easy to adapt.

Advantages:
IP20 rating
Up to 488 I/O connections in 60 cm
Pluggable terminals with spring clamp wire terminations
Single part numbers - no assembly required
Backlit LED for diagnostics
Integrated Ethernet switch
Up to 15 I/O modules after a bus node
Ethernet/IP built in web browser
Din rail mounting