Shop for the Murrelektronik 56220 I/O system -

Module Supply: via system connection
Current consumption: max. 25 mA from system, max. 90 mA externally (UI), idle load
Fieldbus: Ribbon cable connection
Sensor-system/actuator supply: 4 x Spring clamp terminals, max. 2.5 mm^2 (max. 12 A)
I/O ports: 24 x Spring clamp plug-in terminals, max. 2.5 mm^2
Operating voltage: 24 V DC (EN 61131-2)
Protection: IP20
Mounting method: DIN-rail mountable (EN 60715)
Temperature range: 0 - 55 degrees Celcius (storage temperature -20 - 85 degrees Celcius)
Dimensions H x W x D: 117x56x47 mm
Conversion time (analog): max. 1 ms (per channel)
Resolution (analog): 15 Bit sign
Accuracy: max. 0.5%
Galvanic isolation: 500 V DC between inputs and internal communication
Communication status: via LED
Diagnostic via LED: per module and channel
Diagnostic via BUS: per module and channel
Monitoring - under voltage: yes
Monitoring - no voltage: no
Short circuit and overload: yes
Actuator warning: per channel via LED and BUS
Wire break upper/lower limit overload: per channel via LED and BUS
Load: min. 1 kOhm, (EN 61131-2)
Input range: /-10 V DC, 0 - 10 V DC
Load: max. 600 Ohm, (EN 61131-2)
Input range: 0 - 20 mA, 4 - 20 mA

Murr Elektronik Cube20 series is an IP20 rated in-cabinet I/O system designed for ease of installation with a high I/O density in a single space. It can connect up to 15 I/O modules, which gives you up to 488 I/O connections within 90 cm. Cube20 was designed to minimize assembly time, so one part number for one I/O module is all that is necessary when ordering. The I/O modules are connected to each other with a built in ribbon cable for backplane communication and power. Easy to plan, easy to install, easy to adapt.

Advantages:
IP20 rating
Up to 488 I/O connections in 60 cm
Pluggable terminals with spring clamp wire terminations
Single part numbers - no assembly required
Backlit LED for diagnostics
Integrated Ethernet switch
Up to 15 I/O modules after a bus node
Ethernet/IP built in web browser
Din rail mounting